Unihertz Jelly 2E Touchscreen Module Replacement Tutorial - Unihertz

Unihertz Jelly 2E Touchscreen Module Replacement Tutorial

This tutorial will go through the process of replacing the Touchscreen Module of Unihertz Jelly 2E Smartphone.
Unihertz Jelly 2E Earpiece Replacement Tutorial Reading Unihertz Jelly 2E Touchscreen Module Replacement Tutorial 2 minutes
Unihertz Jelly 2E Touchscreen Module Replacement Tutorial

This tutorial will go through the process of replacing the Touchscreen Module of Unihertz Jelly 2E Smartphone.

It is important that you read the entire guide and make sure you can complete all the steps before you start to replace the Touchscreen Module of your Unihertz Jelly 2E smartphone. Otherwise, finding a local trained repair specialist to conduct the repair is recommended.

How to Replace the Touchscreen Module of Unihertz Jelly 2E

How to Replace the Touchscreen Module of Unihertz Jelly 2E Step by Step

Unihertz Jelly 2E Touchscreen Module Replacement Tutorial Step 01

Step 01

Remove the screw located at the bottom of the phone body.
Unihertz Jelly 2E Touchscreen Module Replacement Tutorial Step 02

Step 02

Use a suction cup tool to separate the screen from the phone body.
Unihertz Jelly 2E Touchscreen Module Replacement Tutorial Step 03

Step 03

Remove the two screws on the protective bracket.
Unihertz Jelly 2E Touchscreen Module Replacement Tutorial Step 04

Step 04

Take off the protective bracket.
Unihertz Jelly 2E Touchscreen Module Replacement Tutorial Step 05

Step 05

Disconnect the two cables between the screen and the motherboard.
Unihertz Jelly 2E Touchscreen Module Replacement Tutorial Step 06

Step 06

Transfer the thermal silicone adhesive from the existing screen to the motherboard.
Unihertz Jelly 2E Touchscreen Module Replacement Tutorial Step 07

Step 07

Transfer the proximity sensor and earpiece from the existing screen to the new screen (Note: The contact points of the earpiece should be facing upwards).
Unihertz Jelly 2E Touchscreen Module Replacement Tutorial Step 08

Step 08

Connect the two cables between the screen and the motherboard.
Unihertz Jelly 2E Touchscreen Module Replacement Tutorial Step 09

Step 09

Install the protective bracket and tighten the two screws on it.
Unihertz Jelly 2E Touchscreen Module Replacement Tutorial Step 10

Step 10

Install the screen, ensuring that it securely fits onto the phone body.
Unihertz Jelly 2E Touchscreen Module Replacement Tutorial Step 11

Step 11

Tighten the screw located at the bottom of the phone body.