Unihertz Atom L/XL Type-C Interface Replacement Tutorial

This tutorial will go through the process of replacing the type-C interface of Unihertz Atom L/XL smartphone.

It is important that you read the entire guide and make sure you can complete all the steps before you start to replace the type-C interface of your Unihertz Atom L/XL smartphone. Otherwise, finding a local trained repair specialist to conduct the repair is recommended.

How to Replace the Type-C Interface for Unihertz Atom L/XL

How to Replace the Type-C Interface for Unihertz Atom L/XL Step by Step

	Step 1 Remove the 3 screws on the right side bar
	Step 2 Remove the right side strip
	Step 3 Remove the 3 screws on the left side bar
	Step 4 Remove the SIM card tray
	Step 5 Remove the left side strip
	Step 6 Remove the 10 screws on the rear shell
	Step 7 Remove the back shell Pay attention to the waterproof glue
	Step 8 Insert the 5 screws and fixing bracket on the type-c FPC
	Step 9 Remove the 3.5mm headphone jack Pry open the 3 cable interfaces on the type-c FPC
	Step 10 Remove the type-c FPC
	Step 11 Take out the new type-c FPC (Pay attention to check whether the purchased type-c FPC matches the mobile phone)
	Step 12 Install type-c FPC Connect the cable interface on the type-c FPC Fix the 3.5mm headphone jack
	Step 13 Install the 5 screws and fixing bracket on the type-c FPC
	Step 14 Install the rear case and 10 screws
	Step 15 Install the left side strip
	Step 16 Install the SIM card tray Install the 3 screws on the left side rail
	Step 17 Install the right side strip
	Step 18 Install the 3 screws on the right side bar

Step 1 Remove the 3 screws on the right side bar

Step 2 Remove the right side strip

Step 3 Remove the 3 screws on the left side bar

Step 4 Remove the SIM card tray

Step 5 Remove the left side strip

Step 6 Remove the 10 screws on the rear shell

Step 7 Remove the back shell Pay attention to the waterproof glue

Step 8 Insert the 5 screws and fixing bracket on the type-c FPC

Step 9 Remove the 3.5mm headphone jack Pry open the 3 cable interfaces on the type-c FPC

Step 10 Remove the type-c FPC

Step 11 Take out the new type-c FPC (Pay attention to check whether the purchased type-c FPC matches the mobile phone)

Step 12 Install type-c FPC Connect the cable interface on the type-c FPC Fix the 3.5mm headphone jack

Step 13 Install the 5 screws and fixing bracket on the type-c FPC

Step 14 Install the rear case and 10 screws

Step 15 Install the left side strip

Step 16 Install the SIM card tray Install the 3 screws on the left side rail

Step 17 Install the right side strip

Step 18 Install the 3 screws on the right side bar