Unihertz Atom XL Battery Replacement Tutorial

This tutorial will go through the process of replacing the battery of Unihertz Atom XL smartphone.

It is important that you read the entire guide and make sure you can complete all the steps before you start to replace the battery of your Unihertz Atom XL smartphone. Otherwise, finding a local trained repair specialist to conduct the repair is recommended.

How to Replace the Battery for Unihertz Atom XL

How to Replace the Battery for Unihertz Atom XL Step by Step

	Step 1 Remove the 6 screws from the side edge bezel, remove the side edge bezel and take out the SIM card tray gently.
	Step 2 Remove the ten screws from the rear panel.
	Step 3 Remove the rear panel assembly.
	Step 4 Remove the four screws on the antenna module.
	Step 5 Remove the antenna module.
	Step 6 Remove the seven screws on the dmr-006 Intercom module.
	Step 7 Remove the five cable interfaces on the dmr-006 Intercom module.
	Step 8 Remove the dmr-006 Intercom module.
	Step 9 Remove the two brackets.
	Step 10 Tear off the battery adhesive strip from the black part and gently pull it outward.
	Step 11 Remove the original battery.
	Step 12 Take out the replacement battery and peel off the protective film from the battery adhesive strip.
	Step 13 Fasten the battery cable interface and fix the battery.
	Step 14 Install the cable interface above the battery.
	Step 15 Install two brackets.
	Step 16 Install the dmr-006 Intercom module and fasten the cable interface.
	Step 17 Install the seven screws on the dmr-006 Intercom module.
	Step 18 Install the antenna assembly and install the four screws on the antenna assembly.
	Step 19 Install the rear panel assembly.
	Step 20 Tighten the ten screws on the rear panel assembly.
	Step 21 Install the SIM card tray, install the side edge bezel, and tighten the six screws on it.

Step 1 Remove the 6 screws from the side edge bezel, remove the side edge bezel and take out the SIM card tray gently.

Step 2 Remove the ten screws from the rear panel.

Step 3 Remove the rear panel assembly.

Step 4 Remove the four screws on the antenna module.

Step 5 Remove the antenna module.

Step 6 Remove the seven screws on the dmr-006 Intercom module.

Step 7 Remove the five cable interfaces on the dmr-006 Intercom module.

Step 8 Remove the dmr-006 Intercom module.

Step 9 Remove the two brackets.

Step 10 Tear off the battery adhesive strip from the black part and gently pull it outward.

Step 11 Remove the original battery.

Step 12 Take out the replacement battery and peel off the protective film from the battery adhesive strip.

Step 13 Fasten the battery cable interface and fix the battery.

Step 14 Install the cable interface above the battery.

Step 15 Install two brackets.

Step 16 Install the dmr-006 Intercom module and fasten the cable interface.

Step 17 Install the seven screws on the dmr-006 Intercom module.

Step 18 Install the antenna assembly and install the four screws on the antenna assembly.

Step 19 Install the rear panel assembly.

Step 20 Tighten the ten screws on the rear panel assembly.

Step 21 Install the SIM card tray, install the side edge bezel, and tighten the six screws on it.