Unihertz Titan Slim USB Charging Board Replacement Tutorial

This tutorial will go through the process of replacing the Type-C_FPC assembly of Unihertz Titan Slim smartphone.

It is important that you read the entire guide and make sure you can complete all the steps before you start to replace the Type-C_FPC assembly of your Unihertz Titan Slim smartphone. Otherwise, finding a local trained repair specialist to conduct the repair is recommended.

How to Replace the USB Charging Board on Unihertz Titan Slim

How to Replace the Type-C_FPC Assembly for Unihertz Titan Slim Step by Step

	Step 1 Put the back shell of the mobile phone on the heating platform to heat You can also use a heat gun to heat along the edge of the rear shell
	Step 2 Wait until the double-sided tape on the back cover is softened, use a suction cup tool and a crowbar to pry off the back cover (be careful not to damage the glass on the back cover)
	Step 3 Remove the back shell
	Step 4 Remove 11 screws
	Step 5 Remove the WIFI/BT antenna bracket, NFC antenna bracket, and main antenna bracket
	Step 6 Pry open the cable interface on the antenna board Remove the antenna board
	Step 7 Pry open the cable interface on type-c_FPC Remove type-c_FPC
	Step 8 Install the rubber ring on the old type-c_FPC to the new type-c_FPC
	Step 9 Install type-c_FPC Connect the cable interface on type-c_FPC
	Step 10 Install the antenna board Connect the cable interface on the antenna board
	Step 11 Install the main antenna bracket, NFC antenna bracket, WIFI/BT antenna bracket
	Step 12 Install 11 screws
	Step 13 Install the rear case