Unihertz Titan Slim Keyboard Assembly Replacement Tutorial

This tutorial will go through the process of replacing the keyboard assembly of Unihertz Titan Slim smartphone.

It is important that you read the entire guide and make sure you can complete all the steps before you start to replace the keyboard assembly of your Unihertz Titan Slim smartphone. Otherwise, finding a local trained repair specialist to conduct the repair is recommended.

How to Replace the Keyboard Assembly for Unihertz Titan Slim

How to Replace the Keyboard Assembly for Unihertz Titan Slim Step by Step

	Step 1 Put the back shell of the mobile phone on the heating platform to heat You can also use a heat gun to heat along the edge of the rear shell
	Step 2 Wait until the double-sided tape on the back cover is softened, use a suction cup tool and a crowbar to pry off the back cover (be careful not to damage the glass on the back cover)
	Step 3 Remove the back shell Clean up the residual double-sided tape
	Step 4 Remove 11 screws
	Step 5 Remove the WIFI/BT antenna bracket, NFC antenna bracket, and main antenna bracket
	Step 6 Pry open the cable interface on the antenna board Remove the antenna board
	Step 7 Pry open the cable interface on type-c_FPC Remove type-c_FPC
	Step 8 Pry open the 9 cable ports on the motherboard
	Step 9 Remove the two SIM card trays
	Step 10 Remove the motherboard
	Step 11 Remove the fixing screws of the keyboard
	Step 12 Open the keyboard from the gap (note: the keyboard and the front panel are connected by double-sided tape)
	Step 13 Tear off the double-sided adhesive film on the back of the new keyboard
	Step 14 Fix the cables on the keyboard and install the connection cables from the old keyboard to the new keyboard
	Step 15 Pass the cable through the gap in the front panel and install the keyboard
	Step 16 Install the fixing screws of the keyboard
	Step 17 Check whether the microphone fixing rubber ring falls off
	Step 18 Install type-c_FPC
	Step 19 Install the antenna board Connect the cable interface on the antenna board
	Step 20 Install the motherboard
	Step 21 Connect the 10 cable ports on the motherboard
	Step 22 Install the main antenna bracket, NFC antenna bracket, WIFI/BT antenna bracket
	Step 23 Install 11 screws
	Step 24 Install the rear case